Fork; Rear Suspension Leverage - Betamotor XTRAINER 250 2T EUROPA Mode D'emploi

4

FORK

17Nm
To maintenance refer at an authorized
service center Betamotor.
To check the tightening torques see as
shown in the figure.
WARNING:
Tightening of the screws should be carried
out by adjusting the torque wrench to the
stability torque with repeated tightening
until stability torque has been achieved.
12Nm
REAR SUSPENSION
70Nm
LEVERAGE
In order to guarantee optimal operation
and duration over time of the progressive
leverage of the rear suspension, it is rec-
ommended to periodically check correct
tightness of nuts and bolts.
Verify that suspension nuts and bolts are at
the indicated torque.
90Nm
90Nm
70Nm
EN
66