Bleeding The Front Brake - Betamotor XTRAINER 250 2T EUROPA Mode D'emploi

BLEEDING THE FRONT BRAKE

To bleed air from the front brake circuit,
proceed as follows:
•Remove the rubber cap 1 from the valve 2.
•Open the sump cap.
•Place one end of a small transparent tube
into the valve 2, and the other end inside
a container.
•Pump with the brake lever 2/3 times and
keep the lever pressed.
•Unscrew the valve and let the oil drain.
•If are still visible in the tube repeat above
operation until obtaining a continuous
outflow of oil within no air bubbles.
•Close the valve and release the lever.
NOTE:
During this procedure, continuously top up
the brake pump thank to replace the oil that
is out flowing.
•Remove the tube.
•Replace the rubber cap.
•Close the oil reservoir cap.
Use the liquid indicated on page 16 in
the "Recommended lubricants and liquids"
table.
WARNING:
The brake fluid is extremely corrosive. Take care not to spill it on the paintwork.
Wear appropriate protective clothing and protection gloves.
Keep coolant out of reach of children.
WARNING: Avoid any direct contact of the liquid with skin, eyes or clothing.
If this happens:
- with the eyes, rinse immediately with plenty of water and seek medical advice.
- with skin, immediately clean contaminated areas with soap and water. Change
clothing that is contaminated with liquid.
If liquid is swallowed, contact a doctor immediately.
2
1
57
4
EN