Adjusting The Spring Preload; Static Sag Load Test - Betamotor XTRAINER 250 2T EUROPA Mode D'emploi

3
EN

ADJUSTING THE SPRING PRELOAD

To adjust the spring preload, use the pro-
cedure described below:
Loosen the locking dowel A.
Turn the ring nut B until you reach the
desired preload.
Lock the locking dowel A.
A
For standard setting, refer to page 11.
Note: for movement of the rings use a
specific sector key with square pin.
B

STATIC SAG LOAD TEST

To verify the static sag of the shock absor-
ber proceed as follows:
H
1
- Place the motorcycle on the work stand.
- Measure the vertical distance between
the rear wheel axle and a reference point
on the rear fairings.
- Write down the dimension H
- Remove the work stand.
- Keep the motorcycle in vertical position
and measure again the distance between
the wheel axle and the reference point
previously established.
- Write down the dimension H
H
2
Verify that the value of the static com-
pression X = H
shown on page 11. Otherwise, perform
the adjustment of the spring preload as
described above.
46
.
1
.
2
- H matches the one
1 2