Tightening Torque Overview - Betamotor XTRAINER 250 2T EUROPA Mode D'emploi

TIGHTENING TORQUE OVERVIEW

Here below is an overview of the tightening torque of all pieces subject to adjust-
ment or maintenance:
Wheel pin
Fork foots - wheel pin
Cavallotto parastelo sinistro
Steering head base - fork legs
Steering head - fork legs
Stem pin on steering head
Lower handlebar u-bolt - steering head
Upper handlebar u-bolt -
lower handlebar u-bolt
Wheel pin
Rear shock absorber - frame
Rear shock absorber - rocker arm
Connecting rod - frame
Connecting rod - rocker arm
Rocker arm - swinging arm
Gearbox oil drain plug
Pins motor - frame
Brackets to attach the head - frame (front fixing)
Brackets to attach the head - frame (rear fixing)
Brackets to attach the head - motor
M Medium strength threadlock
* WARNING:
Tightening of the screws should be carried out by adjusting the torque
wrench to the stability torque with repeated tightening until stability torque
has been achieved.
Forecarriage
Tightening torque [Nm]
Rear axle
Tightening torque [Nm]
Engine
Tightening torque [Nm]
Engine - Frame
Tightening torque [Nm]
77
Threadlock
50
20
1,5
12*
17*
20
40
25
Threadlock
130
70
70
90
90
90
Threadlock
15
Note
45
35
M
35
35
4
M
M
EN