Adjusting Fork; Adjustment Of The Handlebar Position; Adjusting The Rebound Damper; Adjusting The Spring Preload - Betamotor XTRAINER 250 2T EUROPA Mode D'emploi

3
Apply the handlebar.
6
Apply the top u-bolt.
Refit the screws 6. Tighten to the torque
indicated.
25Nm
ADJUSTMENT OF THE
1
HANDLEBAR POSITION
The handlebar can be adjusted by rotating
it back and forth.
To adjust the handlebar loosen screws 1.
Position the handlebar according to re-
quirements.
25Nm
Tighten to the torque indicated.

ADJUSTING FORK

ADJUSTING THE REBOUND
DAMPER
The hydraulic rebound damper determines
the behaviour of the telescopic fork during
extension and can be adjusted by means
of screw A. Turning the screw clockwise in-
A
creases the action of the rebound damper;
turning it anticlockwise decreases the ac-
tion of the rebound damper.
For standard calibration, refer to page 11.
B

ADJUSTING THE SPRING PRELOAD

Spring preload is adjusted by means of
screw B. Turning clockwise will increase
the preload, while rotating counter- clock-
wise decreases the preload.
For standard setting, refer to page 11.
EN
44