Conversion Of Neuro Classic; Maintenance; Repairing The Bearing Nut Bore - FIOR & GENTZ NEURO CLASSIC Notice D'utilisation

10.3 Conversion of NEURO CLASSIC

As a supporting joint, the NEURO CLASSIC system ankle joint can be converted into the main joint if the
system stirrup from the main joint has been used.
1 Demount the cover plate of the NEURO CLASSIC system joint.
2 To convert into system ankle joints with feather keys, press the feather
keys with pin into the joint's upper part by using the outer assembly/
lamination dummy. Additionally, you need a longer bearing nut. To
do so, use the bearing nut, the feather keys with pin and the outer
assembly/lamination dummy from the respective set for converting to
plug + go modularity.
3 Mount the functional unit or the cover plate of the main joint in the
correct system width (fig. 21).

11. Maintenance

Check the system joint for wear and functionality every 6 months. Also check the functionality after every
maintenance carried out.
Joint Component
adjusting screw
securing pin
bore for bearing nut of
system stirrup
sliding washer
bearing nut
Secure the screws for the cover plate with the torque corresponding to the system width and LOCTITE® 243
medium strength during every maintenance (see paragraph 8.4). Remove all adhesive residues first.

11.1 Repairing the Bearing Nut Bore

Insert a repair bushing if the bore for the bearing nut at the system
stirrup is worn out.
1 Clamp the system stirrup firmly into a vice.
2 Bore and ream the hole until it has reached the desired dimen-
sion (fig. 22 and 23).
3 Insert the repair bushing made of bronze completely into the
bore.
Problem
wear
wear
oversize
wear
wear
Measure
replacing adjusting screw
replacing securing pin, see paragraph 9.2
inserting repair bushing,
see paragraph 11.1
replacing sliding washer,
see paragraph 11.2
replacing bearing nut
fig. 22
fig. 21
fig. 23
31