FIOR & GENTZ NEURO CLASSIC Notice D'utilisation page 23

Risk of Falling Due to Improper Handling
Inform the patient about the correct use of the system joint and potential dangers especially with regards
to:
- moisture and water as well as
- excessive mechanical stress (e.g. due to sports, increased activity or weight gain).
Risk of Falling Due to Loosely Attached Cover Plate
Mount the cover plate to the system joint according to the assembly instructions in these instructions for
use. Secure the screws with the specified torque and the corresponding adhesive and make sure that no
sliding washers are damaged in the process.
Risk of Falling Due to Permanent Higher Load
If patient data has changed (e.g. due to weight gain, growth or increased activity), recalculate the load
capacity of the system joint. For this purpose, use the Orthosis Configurator or contact Technical Support.
Risk of Falling Due to Improper Shoe/Wrong Shoe Pitch
Advise the patient to wear a shoe to which the orthosis is adjusted in order to avoid joint dysfunction.
Risk of Falling Due to Incorrectly Adjusted Adjusting Screw
Adjust the adjusting screw according to the information in these instructions for use. Do not make a fine
adjustment of more than 10° and secure the adjusting screw with the securing pin and the corresponding
adhesive.
Damage to the Anatomical Joint Due to Incorrect Position of the Joint's Mechanical Pivot Point
Determine the joint's mechanical pivot points correctly in order to avoid a permanent incorrect load on the
anatomical joint. Please refer to the online tutorials on our website or contact Technical Support.
Jeopardising the Therapy Goal by Not Providing the Necessary Free Movement
Check if the system joint moves freely in order to avoid restrictions of the joint function. Use suitable
sliding washers according to the information in these instructions for use.
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
23