Chain Dialing - Depaepe SecurAccess PMR Notice D'utilisation

Table des Matières

Les langues disponibles

Notice SecurAccess PMR

Setting to modify

M1 Key n°4

M2 Key n°4

3.8. Chain dialing

This feature, when activated, will automatically keep on dialing a sequence of numbers stored into

the same memory/off-hook button if the other party does not answer or if busy line tone is detected, it

will only stop when another party answers.

Up to 5 different numbers can be stored in each memory and the dialing sequence can be repeated

up to 9 times. Time elapsed before the next call can be adjusted.

Programming this feature can be done locally or remotely.

Each button can store up to 5 numbers but, in order to activate the chain dialing, at least one number

must be stored to in order to repeat the dialing sequence (in case of just one number, this number

only would be repeated).

Example :

Setting to modify

Number 1 Key n°1 (mandatory)

Number 2 for chain dialing on key n°1

Number 3 for chain dialing on key n°1

Number 4 for chain dialing on key n°1

Number 5 for chain dialing on key n°1

If a busy tone is detected, the unit will automatically dial the next number stored in the memory. In

case of no answer, time elapsed before dialing the following number stored can be adjusted as

shown below:

Setting to modify

Elapsed time before next call

In case of no busy tone and no answer, the dialing sequence can be repeated up to 9 times, choice

of the number of times can be made as shown:

Setting to modify

Repeated dial

When the total numbers of calls has been completed, the SecurAccess will stop dialing and will hang

up.

Example N°1:

A list of 5 numbers stored. Repeated dial selection is 9. In case of busy tone and (or) no answer, the

SecurAccess will dial 10 times the list of 5 numbers (1 first trial plus 9 repeated trials).

Example N°2:

Code

Setting choice

Factory settings are shown in grey

3 5

Keep this memory empty

3 6