Entering Remote Programming Mode; Programming Rules - Depaepe SecurAccess PMR Notice D'utilisation

Notice SecurAccess PMR

the code, 1 "beep" tone confirms a wrong code was entered: resume the operation at
point 4.

entering the programming mode.
Keep depressed M1 (off-hook memory button) and *
Release M1
Release *
Enter
2 "beep" tones
Note: All correct entries are confirmed by a double "beep" tone. Wrong entries are confirmed by a low long
"beep" tone and the unit will hang up.

3.2. Entering remote programming mode

1. Call the SecurAccess and wait until it automatically answers (the number of rings before
automatic answer can be changed, factory setting is 3 rings).
2. Two "beep" tones are emitted and within the following 4 seconds, press * to enter the
programming mode (above 4 seconds, a normal communication is established). Another
double "beep" tones confirms entering the programming mode.
3. Within the following 8 seconds, enter the 4 digits programming access code (0000 with factory
settings):

the code, 1 "beep" tone confirms a wrong code was entered: resume the operation.

entering the programming mode.
Calling the SecurAccess using a Tone dialing telephone.
Dial 0XNNNNNNNN
2 "beep" tones
Enter
2 "beep" tones
Enter 0000
2 "beep" tones
Note: All correct entries are confirmed by a double "beep" tone. Wrong entries are confirmed by a low long
"beep" tone and the unit will hang up.

3.3. Programming rules

1. Enter the programming mode (local or remote)
2. Choose the setting you wish to modify (See list of settings page XX) and enter its setting
access code.
If a wrong code is entered or if it takes more than 8 seconds to enter
If the code is correct, 2 "beep" tones will be emitted confirming
0000
If a wrong code is entered or if it takes more than 8 seconds to enter
If the code is correct, 2 "beep" tones will be emitted confirming
*
2 "beep" tones: entering the programming mode
4 digits access code (0000: factory settings)
confirming entering the programming mode
Calling the SecurAccess
The SecurAccess answers and goes off-hook
Entering the programming mode
Confirming the entry
4 digits (0000 by default)
Confirming the entry
36