Dry Contact; Exit Button - Depaepe SecurAccess PMR Notice D'utilisation

Notice SecurAccess PMR

4.5. Dry contact

This feature can be used to drive a video recording system, a light, an alarm, etc.
It provides a dry NC contact when the unit is off-hook.

4.6. Exit button

The Exit button feature can be used to activate a door latch electrical relay or a double
Security door latch electrical relay through is NC driving contact.
WARNING: If switch activation exit button is ON, door latch contact COM/NO/NC (see 12.10) must
not be used. The door latch must be connected with red terminal (NO) provided for this purpose. (see
diagram below).
This feature requires an external power supply (included in package) (page 28) TRT3 24V DC/AC 1A
(LPS) double insulation (sold by Depaepe SAS) as well as the dedicated switch activation (see
diagram below).
A switch allows the choice of the door latch activation with exit button duration (2,4,6,8,10 or 20
seconds), all the dipswitch levers are OFF, the delay time will be 20 seconds).
TRT3 (TNV-3) access : dry contact
closed when off-hook. Up to 50
Volts DC/AC 50 Hz 100 mA
Power
supply
44
Video