Remote Door Latch Activation; Local Door Latch Activation (Model With Keypad); Programming; Entering Local Programming Mode - Depaepe SecurAccess PMR Notice D'utilisation

Notice SecurAccess PMR
1. When pressing again one of the "off-hook" buttons.
2. No answer duration elapsed.
3. Timed conversation duration elapsed.
4. The other party hangs up and reversed polarity is detected.
5. Busy line tone detection (440 Hz).
6. No speech and no noise on line during 5 minutes.

2.5. Remote door latch activation

A party called by the SecurAccess PMR can activate the door latches relays by entering one of the 4
digits stored codes corresponding to the relay on a tone telephone keypad.
- If a wrong code is entered, 1 "beep" tone will be emitted, the green icon
message "code error" will be clearly announced, the unit will not hang up waiting for the right code.
- If a right code is entered, 2 "beep" tones will be emitted, the door latch will be activated, the green
icon will light up and the message "door open" will be clearly announced, and the unit will hang up.
- If the same code is assigned to the two door latches relays, the two relays will be activated
according to their respective activation time.
If the "fast opening" selection is activated, entering "0#" or "0*" will be enough to activate the door
latch 1.
Note: the door latch code can be stored in a one touch memory button of the called party.
Caution: activation of this code requires a Tone compatible telephone and PABX.

2.6. Local door latch activation (model with keypad)

The keypad on the SecurAccess PMR can be used with the gate button to active a door latch.
A door latch can be activated by using the gate button followed by one of the 4 digits stored codes
associated to the relay.
- If a wrong code is entered, 1 "beep" tone will be emitted, the green icon
message "code error" will be clearly announced, the unit will not hang up waiting for the right code.
- If a right code is entered, 2 "beep" tones will be emitted, the door latch will be activated, the green
icon will light up and the message "door open" will be clearly announced and the unit will hang up.
- If the same code is assigned to the two door latches relays, the two relays will be activated
according to their respective activation time.

3. Programming

3.1. Entering local programming mode

1. Open the unit (only if the model has no front panel keyboard)
2. Connect to the telephone line
3. Reach the front panel or inside programming keypad
4. Press "*" key and, while keeping it depressed, press one of the off-hook memory buttons.
5. Release the off-hook memory button first and the "*" key after : 2 "beep" tones will confirm
entering the programming mode.
6. Enter the 4 digits code within 8 seconds :
35
will blink and the
will blink and the