SecurAccess Compact PMR – User Guide
Example N°2: : In the remote programming mode, change loudspeaker volume to "medium"
Settings
Loudspeaker volume
Calling the SecurAccess COMPACT PMR using a Tone dialling telephone.
Dial
0XNNNNNNNN
2 "beep" tones
hook
Enter
2 "beep" tones
Enter
2 "beep" tones
Ente
2 "beep" tones
Enter
Enter
2 "beep" tones
3.4. Dialing mode (tone/pulse)
The SecurAccess COMPACT PMR offers the choice of Tone or Pulse dialing. Check whith your operator or
installer before using the unit. Factory setting is Tone dialing.
Setting to modify
Dialling mode
Pulse dialing mark/break ratio
3.5. Loudspeaker volume
For a better comfort, loudspeaker volume can be adjusted to 3 different levels.
Setting to modify
Loudspeaker volume
In very noisy environments, an overboost reception level (+10 dB) can be selected. However, this
feature requires an external power supply (see section § Erreur : source de la référence non trouvée)
3.6. Memory key storing
The SecurAccess COMPACT PMR comes with 1 or 2 off-hook/memory buttons. To store the number
to be dialled when depressing one of these buttons, enter the programming mode and proceed as
follows:
Setting to modify
M1 Key n°1 (mandatory)
Code
Setting choice
06
Low: 0 – Medium : 1 – High : 2
*
0000
06
1
*9
Code
0 0
0 1
Code
0 6
Code
2 0
Calling the SecurAccess COMPACT PMR
The SecurAccess COMPACT PMR answers and goes off-
Entering the programming mode
Confirming the entry
4 digits (Factory setting : 0000)
Confirming the entry
Setting code access
Confirming the entry
Setting choice (medium)
Confirming stored setting
Confirming the operation
Setting choice
Factory settings are shown in grey
Pulse : 0 – Tone : 1
Pulse
66/33 ms : 0
60/40 ms : 1
Setting choice
Factory settings are shown in grey
Low : 0 – Medium : 1 – High : 2
Setting choice
Factory settings are shown in grey
Number to store (* # = pause) (22 digits max)
Conf.
*9
Conf
*9
*9
Conf
*9
Conf.
*9
36