Trouble Shooting - Interacoustics Aqua Stim Instructions D'utilisation

Aqua Stim Water Irrigator Instructions for Use - EN

3.8 Trouble Shooting

LCD Display or Problem
Observed
No Water in Tank
Fill Cool Water
Irrig. Timeout -
No water comes out of the
irrigator handle after irrigator
displays "Ready" and
pressing the irrigation button.
Water dribbles out of the
irrigation handle when the
irrigator is running in Cool or
Warm mode. This happens
before "Ready" state is
reached.
Too Warm
Handle does not light or
respond to button press.
Call TechSupport
(note additional error
message)
Cause
External water tank empty
Water in external tank is warmer
than the desired irrigation
temperature
Irrigator left on for 10 minutes
without performing another
irrigation, will return to Standby
screen
Possible blockage in the irrigator
handle.
Fault in the electronics power
module for the handle.
Residual warm water in the
irrigator preventing reaching the
desired temperature
Electrical connector not making
good contact.
Internal problem requiring
technical support for assistance
Solution
Refill water tank with water at less than
75°F (24°C)
Select Cool / Warm to retry operation
Add cooler water to the external water
tank
Select Cool / Warm to retry operation
Press Cool or Warm to initiate irrigation
procedure, otherwise none
Select Cool / Warm to retry operation
Disconnect the handle from the
irrigator. Push air with a syringe into
the blue tube to flush out water and
impurities. Discard water coming out of
the red tube.
Check the handle's electrical connector
on the back panel is properly
connected.
Stop current operation by pressing
Cool / Warm. Then retry desired
temperature Cool / Warm. Aqua Stim
will purge the internal water by filling
from the external water tank.
Power-down irrigator then check
connections on back.
Call Interacoustics Technical Support
with the additional error message on
the display (e.g. "Level Sense Error"
etc).
Page 17