Migatronic RCI4 Guide De L'utilisateur page 16

Anybus indicators
DeviceNet
# Item
1 Network status LED
2 Module status LED
3 DeviceNet connector
4 M12 Female connector
5 M12 Male connector
Network Status
State Indication
Off Not online / No power
Green On-line, one or more connections are
established
Flashing Green (1 Hz) On-line, no connections established
Red Critical link failure
Flashing Red (1 Hz) One or more connections timed-out
Alternating Self test
Red/Green
Module Status
State Indication
Off No power
Green Operating in normal condition
Flashing Green (1 Hz) Missing or incomplete configuration,
device needs commissioning
Red Unrecoverable Fault(s)
Flashing Red (1 Hz) Recoverable Fault(s)
Alternating Self test
Red/Green
DeviceNet Connector
This connector provides DeviceNet connectivity
Pin Signal
1 V-
2 CAN_L
3 SHIELD
4 CAN_H
5 V+
Description
Negative bus supply voltage
CAN low bus line
Cable shield
CAN high bus line
Positive bus supply voltage
EtherNet IP
# Item
1 Network status LED
2 Module status LED
3 Link/Activity
4 Ethernet Interface
Network Status LED
LED State Description
Off No power or no IP address
Green On-line, one or more connections
established (CIP Class 1 or 3)
Green, flashing On-line, no connections established
Red Duplicate IP address, FATAL error
Red, flashing One or more connections timed out (CIP
Class 1 or 3)
Module Status LED
Note: A test sequence is performed on this LED during
startup
LED State Description
Off No power
Green Controlled by a Scanner in Run state
Green, flashing Not configured, or Scanner in Idle state
Red Major fault (EXCEPTION-state, FATAL
error etc.)
Red, flashing Recoverable Fault(s)
LINK/Activity LED
LED State Description
Off No link, no activity
Green Link established
Green, flickering Activity
16
1 8