Cleaning And Servicing - CONSTRUCTA CC4P86660 Manuel D'utilisation Et Notice D'installation

Display
1 Factory setting (may vary according to model)
15.2 Changing the basic settings
Requirement: The appliance is switched off.
Press and hold for a few seconds.
1.
a The first basic setting is shown on the display.
Use the rotary selector to change the basic setting.
2.
Press ⁠ .
3.
a The next basic setting is shown on the display.
Use to select all of the required basic settings
4.
and change the values.
16 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
16.1 Tips on caring for your appliance
Follow the tips on appliance care to make sure your
appliance functions properly at all times.
Measure
Always keep the appli-
ance clean and remove
dirt immediately. Always
clean the cooking com-
partment after use.
Remove limescale,
grease, starch and albu-
min (e.g. egg white)
stains immediately.
Use the glass tray for
baking very moist cakes.
Use suitable cookware for
roasting, e.g. a roasting
dish.
Use hot air if possible.
16.2 Cleaning products
Only use suitable cleaning agents.
WARNING ‒ Risk of electric shock!
An ingress of moisture can cause an electric shock.
Do not use steam- or high-pressure cleaners to
▶
clean the appliance.
Basic setting
Factory setting
Demo mode
Advantage
Prevents dirt from accu-
mulating and burning on.
Prevents corrosion.
Keeps the cooking com-
partment cleaner.
Keeps the cooking com-
partment cleaner.
Less soiling
Selection
1
= off
= on
1
= off
= on
To save the changes, press and hold
5.
seconds.
Note: The changes to the basic settings will be re-
tained even after a power cut.
15.3 Discarding changes to the basic
settings
Turn the function selector.
▶
a All changes are discarded and not saved.
ATTENTION!
Unsuitable cleaning agents damage the surfaces of the
appliance.
Do not use harsh or abrasive cleaning products.
▶
Do not use cleaning products with a high alcohol
▶
content.
Do not use hard scouring pads or cleaning
▶
sponges.
Do not use any special cleaners for cleaning the ap-
▶
pliance while it is hot.
Only use glass cleaners, glass scrapers or stainless
▶
steel care products if recommended in the cleaning
instructions for the relevant part.
New sponge cloths contain residues from production.
Wash new sponge cloths thoroughly before use.
▶
You can find out which cleaning products are suitable
for each surface or part of the appliance in the indi-
vidual cleaning instructions.
16.3 Cleaning the appliance
Clean the appliance as specified. This will ensure that
the different parts and surfaces of the appliance are
not damaged by incorrect cleaning or unsuitable clean-
ing products.
WARNING ‒ Risk of burns!
The appliance and its parts that can be touched be-
come hot during use.
Caution should be exercised here in order to avoid
▶
touching heating elements.
Young children under 8 years of age must be kept
▶
away from the appliance.
Cleaning and servicing en
Description
Reset the changed settings
to the factory settings.
Switch demo mode on or
off.
Note: Demo mode is only
visible in the first 5 minutes
after connecting the appli-
ance to the mains.
for a few
77