Connecting The Device To The Power Supply; Disconnecting The Device From The Power Supply - Mennekes EverBOX Grip Manuel D'utilisation

7.3

Connecting the device to the power supply

Is the device adequately protected by your elec­
trical installation (house installation), especially for
outdoor use?
Before connecting the device to the electrical
installation, have the installation checked by a
qualified electrician for adequate fuse protection.
¨
Section 5.4
2
3
Fig.: 13. Inserting the plugs into the sockets (example IP67)
f Insert the plug (1) of the connecting cable into the
power supply socket (2).
f Tighten the bayonet ring (3) of the plug at the socket.
7.4
f Before disconnecting electrical consumers, first turn
them off at their own ON/OFF switch.
T
Material damage due to incorrect operation
If you attempt to pull the plug out of the socket via the
cable, you may pull the cable out of the plug enclosure.
f Unplug the device from the socket via the plug enclo­
sure only; do not pull on the cable.
1
Fig.: 14. Unplugging the plugs from the sockets (example
IP67)
f Lift the hinged cover (1) of the supply socket.
f Loosen the bayonet ring (2) of the plug.
f Pull out the plug (3)
Disconnecting the device from the power
supply.
ATTENTION
2
EN
1
3
45