Start-Up; Switching On The Device; Connect Mennekes Charge App To The Device - Mennekes AMTRON Xtra Manuel D'utilisation

4. Start-up

4.1

Switching on the device

T
T
WARNING
Risk of electric shock due to damaged device
Using a damaged device may result in electric shock.
f Do not use the device if there is external damage.
f Mark the possibly damaged device to ensure that no
one uses it.
f Have a qualified electrician rectify the damage immedi-
ately.
f Have an electrician take the device out of service if nec-
essary.
f Switching on the supply voltage.
The "Ready for operation" LED on the LED info field
9
lights up.
4.2 Connect MENNEKES Charge APP to the
device
You cannot use the device with the MENNEKES
Charge APP in "SCU" mode.
The device is operated with a mobile terminal (smartphone,
tablet) via the MENNEKES Charge APP. Your mobile termi-
nal can control the device and shows you all information
about the current charge. In addition, you can start or stop
the current process at any time via remote control.
Requirements:
To operate the device with the MENNEKES Charge APP,
the following requirements must be met:
„ Your mobile terminal has the operating system IOS or
Android.
„ Installation of the MENNEKES Charge APP on a mobile
terminal. The MENNEKES Charge APP is available free
of charge in the Apple App Store and in the Google
Play Store.
„ The device is switched on and ready for use.
„ There is a network connection between the mobile ter-
minal and the device.
12
For some tasks it is necessary to enter a PIN.
These can be found on the set-up data sheet.
After entering an incorrect PIN ten times, PIN
input will be blocked for five minutes.
Automatic connection
f Open the MENNEKES Charge APP.
f Tap "Search for Wallbox" to find the devices on your
network.
f Select the desired device using the serial number (see
name plate).
f Enter PIN1 (APP PIN) of the device and change the
name if necessary.
f Confirm the entry with "Save".
If further devices are to be connected, repeat the above
steps.
Manual connection
In rare cases, the device will not be detected automatically.
You can then connect the device manually.
f Touch "Set up manually".
f Enter the IP address and associated PIN1 (APP PIN) of
the device and change the suggested name as desired.
The IP address differs depending on the configuration
made during setting-up process.
If necessary, contact your responsible service partner.
„ IP address as access point (the mobile terminal is con-
nected to the WLAN of the device): 172.31.0.1
„ IP address for direct connection (The device is connect-
ed to the router with a LAN cable. The mobile terminal
is in the same network): 192.168.0.100
„ IP address for integration into your home network: read-
able in the user interface of your router.
f Confirm the entry with "Save".