Installing The Floor Panel; Removing Sockets; Fitting Sockets - Mennekes EverBOX Grip Manuel D'utilisation

9.1.6 Installing the floor panel

On devices of protection class IP 67, the floor
panel is provided with a seal. If the seal is dam­
aged, the floor panel must be replaced.
Fig.: 26. Installing the fl oor panel
f Place the device on the top side.
f Insert floor panel (1).
f Fasten the circumferential screws (2) of the floor panel
with a suitable tool to 1.2 Nm.

9.1.7 Removing sockets

f Remove the floor panel.
¨ Section 9.1.5
f Loosen the supply leads of the relevant flanged socket
at the protective element, or at the socket.
f Loosen the fastening screws of the flanged socket.
f Remove the flanged socket.

9.1.8 Fitting sockets

f We recommend the use of original spare parts from
MENNEKES for repairs.
f Fit the flanged socket in the same installation
position (as previously removed) and fasten with the
accompanying four screws.
f Connect the supply leads to the relevant residual cur­
1
rent circuit breaker or the socket and check for tight fit.
f Install the floor panel.
¨ Section 9.1.6
2
EN
55