Mennekes EverBOX Grip Manuel D'utilisation page 37

Check the device for defects
If the device is defective, e.g. defective enclosure or
missing components, people can be seriously injured by
electric shock.
f Visually check the device for defects before use. Do
not use a damaged device.
f Mark a damaged device, so that other persons cannot
use it.
f Have a qualified electrician rectify the damage with­
out delay.
Avoid damaging the device
f Do not bend or crimp the cables.
f Do not pull electric cables over sharp edges.
f Do not drive over cables.
f Do not use adapter plugs in conjunction with the
device.
f Keep the device away from heat sources.
f Do not operate stacked devices.
f When using the device, especially outdoors, only con­
nect electrical consumers with suitable and approved
plugs and sockets.
f Do not hang up the device by the connection cable or
use it for transport.
f Only take hold of the plugs and sockets at the enclo­
sure when connecting and disconnecting them. Do
not pull out the plugs and sockets out of the socket at
the cable.
f Use the ON / OFF switches of electrical consumers
connected to the device to switch them off.
f Do not use aggressive cleaning agents or chemi­
cals to clean the device. Otherwise surfaces may be
attacked and damaged.
f Do not place the device in water (e.g. puddles).
f Do not store any objects on the device.
f Only have a qualified electrician carry out repairs on a
damaged device.
f We recommend the use of original spare parts and
accessories from MENNEKES for repairs.
Maintain the device regularly
Lack of or improper maintenance can affect the safety of
the equipment and cause accidents. This can seriously
injure or kill people.
f Have a qualified electrician perform regular mainte­
nance on the device.
Pay attention to ambient conditions
If the permissible ambient conditions are not adhered to,
the functionality and operational safety of the device is
affected. This can cause accidents and severe injuries to
people.
f The unit is not suitable for use in potentially
explosive atmospheres and must not be used in this
environment.
f Avoid strong temperature fluctuations.
f Avoid penetration of water.
EN
35