Briggs & Stratton SIMPLICITY SZT350 Manuel D'utilisation page 16

Masquer les pouces Voir aussi pour SIMPLICITY SZT350:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 112
2.  Install the pins (C, Figure 15) into the holes. 
3. Lower the rear of the bed, pressing down firmly to secure
with the locking clips (D, Figure 15). 
CAUTION
To avoid injury, assistance is required when removing or
installing the cargo bed. 
Suspension Adjustment (if equipped)
The shock assemblies (A, Figure 16 - front shown, rear
similar) can be adjusted to vary the amount of pre-load
applied to the springs. This allows the operator to customize
the ride according to operator's weight and operating
conditions. 
Less Pre-Load: 
• Light operator weight 
• Softer, more cushioned ride 
• Best for relatively flat terrain 
More Pre-Load: 
• Heavy operator weight 
• Stiffer, more rigid ride 
• Better handling and greater stability on hilly terrain 
To Adjust the Spring Pre-Load: 
1. Park machine on a flat, level surface. Disengage the
PTO, pivot the ground speed levers out to the START/
PARK position, and stop the engine. 
2. Turn the pre-load adjustment collar (B, Figure 16) to a
higher notch (-) to decrease the pre-load, or to a lower
notch (+) to increase the pre-load. Make sure all shocks
are set to the same amount of pre-load. 
Maintenance
16
Maintenance Schedule
WARNING
Unintentional sparking can result in fire or electric shock.
Unintentional start-up can result in entanglement, traumatic
amputation, or laceration.
Before performing adjustments or repairs:
• Disconnect the spark plug wire and keep it away from
the spark plug.
• Disconnect battery at negative terminal (only engines
with electric start).
• Use only correct tools.
• Do not tamper with governor spring, links, or other parts
to increase engine speed.
• Replacement parts must be of the same design and
installed in the same position as the original parts.
Other parts may not perform as well, may damage the
unit, and may result in injury.
• Do not strike the flywheel with a hammer or hard object
because the flywheel may shatter during operation.
TRACTOR AND MOWER
Every 8 Hours or Daily
Check safety interlock system
Clean debris off tractor and mower deck
Clean debris from engine compartment
Every 25 Hours or Annually *
Check mower blade stopping time
Check tractor and mower for loose hardware
Check tire pressure
Every 50 Hours or Annually *
Check tractor brakes
Clean battery and cables
See Dealer Annually to
Lubricate tractor and mower
Check mower blades **
* Whichever comes first
** Check blades more often in regions with sandy soils or high
dust conditions.
ENGINE
First 5 Hours
Change engine oil
Every 8 Hours or Daily
Check engine oil level
Every 25 Hours or Annually *
Clean engine air filter and pre-cleaner **
Every 50 Hours or Annually *
Change engine oil
Replace oil filter
Annually
Replace air filter
Replace pre-cleaner

Publicité

Table des Matières
loading

Table des Matières