Altering The Image Compression - Minox Leica M3 2.1 Notice D'utilisation

Delete the last image taken
1. Switch your DCC on by pressing the On/Mode button.
2. Press the On/Mode button untill the mode „dL" for
„delete last image"appears.
3. The symbol „dL" flashes until you confirm this mode
you wish to use.
4. Press the shutter release to confirm and set this
mode. The flashing stops and „dL" is displayed.
5. Press the shutter release again to delete the image.
Delete all images
1. Switch your DCC on by pressing the On/Mode button.
2. Press the On/Mode button until the mode
„dA" for „delete all images" appears.
3. The symbol „dA" flashes until your confirm
this mode you wish to use.
4. Press the shutter release to confirm and set this
mode. The flashing stops and „dA" is displayed.
5. Press the shutter release again to commence the
deleting of all images.

Altering the image compression

To allow you to store as many images in your digital
camera as possible the images taken are automatically
compressed.
The DCC allows you to alter the degree of image com-
pression before taking the shot (compression rate). Al-
ways follow the following instructions for this purpose.
1. Switch on your DCC by pressing
the On/Mode button.
2. Press the On/Mode button until the mode "SP" or
"Fn" appears.
3. If it is in Super Mode, the display indicates "Fn".
If it is in Fine Mode, the display indicates "SP".
4. Press the Shutter Release to set the appropriate
modes. (If you are currently in 'SP' mode, the LCD
displays 'Fn' and if you press the Shutter Release
while the LCD is displaying 'Fn', you will change the
mode from 'SP' to 'Fn'). An acoustic signal confirms
the alteration.
5. Press the On/Mode button until the mode "Lr" or
"Hr" appears.
6. If the current resolution mode is High, the display
indicates "Lr"; if it is in Low Resolution mode, the
display indicates "Hr".
7. Press the shutter release to set the appropriate
resolution mode. (If you are currently in 'Hr' mode,
the LCD displays 'Lr' and if you press the Shutter
Release while the LCD is displaying 'Lr', you will
change the mode from 'Hr' to 'Lr'). An acoustic
13