Cleaning, Care And Maintenance; Troubleshooting - Stiebel Eltron SHW 200 S Utilisation Et Installation

OPERATION

Cleaning, care and maintenance

5. Cleaning, care and maintenance
f Have the electrical safety of the appliance and the func- f
tion of the safety assembly regularly checked by a heating
contractor.
f Never use abrasive or corrosive cleaning agents. A damp f
cloth is sufficient for cleaning the appliance.
Signal anode with consumption indicator
Material damage
!
If the consumption indicator changes colour from white
to red, have the signal anode checked by a heating con-
tractor and if necessary replaced.
1
1 Signal anode with consumption indicator
2 White = anode OK
3 Red = ask your heating contractor to check
Scaling
Almost every type of water deposits lime at high temperatures.
This settles inside the appliance and affects both the performance
and service life. The heating elements must therefore be descaled
from time to time. A qualified contractor who knows the local
water quality will tell you when the next service is due.
f Check the taps/valves regularly. You can remove limescale f
deposits at the tap outlets using commercially available des-
caling agents.
f Regularly activate the safety valve to prevent it from becom- f
ing blocked e.g. by limescale deposits.
www.stiebel-eltron.com
6.
Fault
The water does not heat
up.
The flow rate is low.
If you cannot remedy the fault, notify your heating contractor. To
facilitate and speed up your enquiry, please provide the serial
number from the type plate (no. 000000-0000-000000):
2 3

Troubleshooting

Cause
There is no power.
The aerator in the tap or
shower head is scaled up
or contaminated.
Remedy
Check the fuses/MCBs in
your fuse box.
Clean and/or descale the
aerator or shower head.
Nr.: 000000-0000-000000
Made in Germany
SHW S | 21