Thermometer; Signal Anode; Water Connection And Safety Assembly - Stiebel Eltron SHW 200 S Utilisation Et Installation

INSTALLATION
Installation
Installation
f Fit the cylinder casing. f
f Fit the cable grommet and control panel cover. f
f Push on the temperature selector. f
f If you use the "DHW circulation" connection to install a DHW f
circulation line, you need to cut an opening in the cylinder
casing near the connection (indentation in the foam) for the
DHW circulation line.
f Remove the thermal insulation near the connection. f
f Route the DHW circulation line through the aperture in the f
cylinder casing and fit the DHW circulation line.
f Insulate the "DHW circulation" connection. f
f Insert the supplied adaptor with flat gasket and an extension. f
f Cover the hole in the cylinder casing with the adhesive rose f
supplied.
f Fit the cover and the plinth trim of the cylinder casing. f

10.2 Thermometer

f Insert the thermometer as far as it will go and align it. f
www.stiebel-eltron.com

10.3 Signal anode

Material damage
!
The appliance must not be operated without a consump-
tion indicator or with a damaged one, otherwise water
will leak out once the anode is depleted.
1
1 Transport protection
2 Signal anode with consumption indicator
f Remove the transport protection. f
f Check the consumption indicator for transport damage. f

10.4 Water connection and safety assembly

10.4.1 Safety instructions
Note
Carry out all water connection and installation work in
accordance with regulations.
Material damage
!
When using plastic pipework, observe chapter "Specifi-
cation / Fault conditions".
Material damage
!
Operate the appliance only with pressure-tested taps.
Cold water line
Galvanised steel, stainless steel, copper and plastic are approved
materials.
A safety valve is required.
DHW line
Stainless steel, copper and plastic pipework are approved ma-
terials.
2
SHW S | 23