Safety Instructions; Technical Specifications - APA BULLY Mode D'emploi

GB
Art. Nr. 16526 POWER PACK „BULLY" 1000 Ampere Jump Start
Please read these instructions before starting the Poewr Pack and keep them safely for future
reference.
1
Power cable
2
Crocodile clip (-)
3
Button for the charging status
Important advice before starting:
The "Bully" Power Pack contains an internal accumulator which has to be recharged regularly every 4 to
6 weeks, even if the device is not in use. If the LED indicates a low charging level, the device has to be
recharged immediately. The accumulator has already been charged by the manufacturer. Nevertheless
you should recharge the device with the power cable before using it for the first time. This power cable
is constructed in a way that the accumulator of the device cannot be overcharged.

Safety instructions:

The internal accumulator of the "Bully" Power Pack is a lead-acid battery. This battery is classified as
leak proof and uses a unique sealing technology which ensures that the electrolyte cannot leak from the
battery. If it is necessary to replace this battery, you should ask a qualified technician to execute this
replacement. Every standard battery of the same type can be used to replace the internal battery of the
Power Pack (e.g. from Varta, Moll, etc.). It can be dangerous to work near lead-acid batteries, because
this type of battery produces explosive gasses during the process of charging and starting. To reduce
the risk of an explosion, please read carefully the instructions for this device and the safety instructions
provided by the manufacturer of the car battery. Please take note of the manufacturer's special
instuctions on the battery, as well! Use the "Bully" Power Pack only for bridging lead-acid batteries. It is
not intended to supply electrical low-voltage systems with energy, but solely to be used as a jump start.
Neither should you try to charge dry cell batteries, which are frequently used in the household, because
these dry cells can explode while being charged and they can cause major damage.
- If you are going to work with a lead-acid batterie, always ask another person to stick around in
case you need any help.
- Always keep enough fresh water and soap ready to hand in case you need any.
- Always wear safety glasses and protective clothing and avoid by all means contact of your eyes
with the battery while you are working with it.
- If your skin or your clothes have come into contact with some of the acid of the battery, treat the
affected area with water and soap immediately. See a doctor at once, if despite the treatment with
water and soap you feel any skin irritation or pain in the affected area. If some of the acid has got
into your eyes, rinse them immediately with running cold water for at least ten minutes and see a
doctor afterwards as quickly as possible.
- Do not smoke near the battery and do not light any fires or open lights near it either.
- Do not deposit any tools on the battery, because you run the risk of causing a short circuit by
doing so.
- If you want to work with a lead-acid battery, you should take off any jewellery, because otherwise it
might cause a short circuit.
- Do not use any loose cables near the clips for the jump start of the Power Pack. They might cause
a short circuit in its accumulator and this in turn could lead to an explosion.
- Never connect the crocodile clips with each other. Neither should they touch each other by
accident because flying firebrands might cause a fire.
- Apart from this you also risk an overheating of the accumulator, which in turn can cause an
explosion, as well.

Technical specifications:

Length: 310 mm
Breadth: 200 mm
Height: 290 mm
Crocodile clips' cables:
Length of the power cable:
Self-weight:
Operating instructions
Tension:
Max. jump start capacity:
Capacity of the battery:
about 0,80 m
about 1,30 m
8 kg
4
LED for the charging status
5
12 Volt output contact
6
Crocodile clip (+)
12 V
1000 A
18 Ah
5