Explanation Of Symbols; Safety Notes - APA 16524 Manuel De L'opérateur

4. EXPLANATION OF SYMBOLS

5. SAFETY NOTES

•
This device is not a toy. Keep children away and do not allow children to operate this device!
•
Do not treat packaging material carelessly. This may become a dangerous plaything for a child!
•
Only use this product as intended!
•
Do not manipulate or dismantle the device!
•
For your own safety, only use accessories and spare parts that are stated in these instructions or that are
recommended by the manufacturer!
•
When using lead batteries, always wear protective goggles and clothing.
•
Lead batteries contain aggressive, corrosive acids. Prevent skin and eyes from coming into contact with the
lead battery fluids! Never dismantle the lead battery! Wash affected skin thoroughly using soap and water.
If acid has entered an eye, rinse immediately for at least 10 minutes under clean, running, lukewarm water!
Then immediately consult a doctor!
•
If your clothing has acid on, rinse immediately with plenty of soap and water!
•
Never wear rings, necklaces, watches or similar when handling batteries or chargers. The short-circuiting of
the battery contacts brings a risk of burns and explosion!
•
The power pack is only designed as a starting aid for a vehicle that has a battery of its own. The power pack
cannot replace the vehicle battery.
•
Always store the pole callipers in the designated holders to ensure that the power pack is not at risk of short-
circuiting when not in use.
•
Do not attempt to remove and replace the battery pack of the power pack. If the battery comes to the end of
its useful life, dispose of the entire power pack in accordance with your local guidelines.
•
Never charge the power pack using a damaged charger.
•
Only used the supplied accessories to charge the power pack.
•
Never attempt to start a vehicle when the battery is frozen, this brings a risk of explosion.
•
Always observe the following sequence when disconnecting the power pack from the battery. There is a
risk of explosion: First disconnect the black (-) pole calliper, coil the cable and attach the pole calliper to the
designated holder. Then disconnect the red (+) pole calliper, coil the cable and attach the pole calliper to
the designated holder.
8