Scope Of Delivery; Specifications; Safety Notes - APA 16617 Manuel De L'opérateur

2. SCOPE OF DELIVERY

• 1x Charger
• 1 x Adapter charging cable with pole callipers

3. SPECIFICATIONS

Dimensions:
Weight:
Long mains cable:
Length of charging cable:
Input:
Output:
Motorbike: 12 V DC 2.0 A
Battery capacity:
Protection class:
Ambient temperature:

4. SAFETY NOTES

• The warning triangle labels all instructions important to safety. Always follow these otherwise you could
injure yourself or damage the device.
• Only connect the device to a correctly installed socket. The voltage must correspond to the specification on
the type plate of the device.
• Do not trap the power cable and protect it from sharp edges, damp, heat or oil. The power cable of the unit
cannot be replaced. In the event that the cable is damaged, the unit must be disposed of.
• Do not operate the device or immediately pull the plug if it is damaged or you suspect it may be defective.
In this case, contact our technicians.
• Pull the plug when the device is not in use.
• Keep packaging materials, especially plastic and plastic bags, away from children. Risk of suffocation!
• Remove all plastic from the device before use.
• Lay the mains cable in such a way that you are not hindered by it, and no one is able to accidentally pull it.
• Disconnect the battery charger from the power supply after charging.
• Keep the charger in a place that cannot be accessed by children or unauthorised persons.
• Never operate the device in the vicinity of flammable materials or in an environment prone to explosion.
• Always wear suitable working clothes, protective gloves and goggles. Battery acid is corrosive! Immediately
and thoroughly wash off any splashed acid and consult a doctor if necessary. If battery acid gets into the
eyes, immediately rinse under running water for at least 10 minutes and consult a doctor.
• Do not cover the charger, this may lead to overheating and result in damages. Never set the charger up for
operation on a surface that is insulating (e.g. polystyrene). There is a risk of heat build up!
• If you wish to charge a vehicle battery in the installed state, first park the vehicle safely, put on the parking
brake and switch off the ignition. Cut the battery off from the on-board network of your vehicle. To do this,
consult the manual for your vehicle, or ask your specialist workshop.
• This charger enables you to charge a battery without needing to disconnect it from the on-board network.
If you wish to make use of this option, make sure that your vehicle will not be damaged by this process. For
this purpose, read the manual of your vehicle or ask your specialist workshop.
• For vehicles with a start/stop system, pay attention to the instructions in the vehicle manual regarding
charging of batteries. Only use the connection points specified in the manual. Ask your specialist workshop
or the vehicle manufacturer. (If this instruction is not maintained, damages may be caused to the electrical
systems of the vehicle).
• When pulling the mains cable out of the socket, only hold the plug.
180 x 80 x 45 [mm]
0.465 kg
1.50 m
1.00 m + 0.50 m adapter charging cable
220-240 V AC 50/60 Hz
6 V mode: 6 V DC 2.0 A
Auto: 12 V DC 4.0 A
6 V min 1.2 Ah max. 14 Ah
12 V min 1.2 Ah max. 120 Ah
IP65 (only device housing, not connection and charging cable)
-5 °C to +40 °C
• 1 x Operating instructions
• 1 x Adapter charging cable with eyes
9