Changing The Drive Belts; Disposal; Service Notes - Meister MEH900-1 Traduction Du Manuel D'utilisation Original

Figure 8-2: Swivel the protective cover
to the side. Push the blades out with a
screwdriver.
A stuck blade can be
loosened with a gentle tap on
the front side.
Rotate the blade or insert a new blade.
Figure 8-3: Align the press jaws and the
blade parallel to the plane shoe.
Tighten the 3 nuts up again.
Changing the drive belt
The drive belt must be
changed if it no longer drives
the blade drum powerfully as
a result of ageing or material
fatigue.
Driven moving parts. Risk of injury if
switched on unintentionally. Separate
the device from the power supply.
Figure 9-1: Open up the drive belt
housing.
Figure 9-2: Insert a screwdriver between
the drive belt and the drive wheel.
Rotate the drive wheel and lever the
drive belt out.
Insert the new drive belt in such a way
that it is correctly positioned in the
grooves of the drive wheels.
Close the drive belt housing.
58
MW-5460140-Bedien-2005.indd 58 MW-5460140-Bedien-2005.indd 58
13 – Disposal
After the lifetime has expired:
Ensure that the device is sent for
environmentally-friendly recycling.
Dispose of the device
according to regional
regulations.
Do not put it in the
household waste.
In accordance with the European
guideline 2012/19/EU on used electrical
and electronic devices and the
implementation of such in national law,
used electrical devices must be collected
separately for disposal and sent for
environmentally friendly recycling.
Recycling alternative to returning:
The owner of the electrical device is, as
an alternative to returning it, obliged to
assist in the proper recycling in the event
that they give up ownership. The used
device may also be handed in to a returns
point which will carry out the elimination
in the interests of the national recycling
economy and waste laws.
Not affected are the accessories and aids
belonging to the used devices which do
not have electrical components.
14 – Service instructions
• Store the machine, operating
instructions and where necessary the
accessories in the original packaging.
In this way you will always have all the
information and parts ready to hand.
07.05.20 11:22 07.05.20 11:22