Tv 303 Controller Installation - Agilent Technologies TV 303 Notice De Mode D'emploi

17 Technical Information

TV 303 Controller Installation

TV 303 Controller Installation

The controller can be mounted in two positions:
To install the controller execute the following procedures.
Bottom mounting
See the following figure.
1. Turn the pump upside-down;
2. Screw the 4 fixing studs (provided with the accessories bag) in the
holes on the bottom of pump;
3. Place the controller on the studs aligning the 4 rubber holes on the
top of the controller case;
4. Press the controller towards the pump;
5. Turn the pump again;
6. Plug the line cord and connect the pump cable to the pump;
7. Connect the mating connector with the jumper on the interlock
signal to start the pump.
252/268
bottom mounting (as per the complete system)
side mounting.
TV 303 User Manual / 87-901-019-01 (A)