Agilent Technologies TV 303 Notice De Mode D'emploi page 213

Power cable
Serial communication
(Navigator kit)
Storage temperature
Input
Lubricant
Installation category
Installation category
Storage temperature
Weight kg (lbs):
Kit:
Controller
* (According to standard DIN 28 428, the base pressure is that
measured in a leak-free test dome, 48 hours after the completion of
test dome bake-out, with a Turbopump fitted with a ConFlat flange
and using the recommended pre-vacuum pump).
When the TV 303 has been stored at a temperature less than 5°C, wait until the
NOTE
system has reached the above mentioned temperature.
TV 303 User Manual / 87-901-019-01
EN-CENELEC 55011
IEC 1000-4-2 (ex 801-2)
IEC 1000-4-3 (ex 801-3)
IEC 1000-4-4 (ex 801-4)
EN 61010-1 (IEC 1010-1)
EN 1012-2
With European or NEMA plug 3 meters long (optional)
RS232 cable with a 9-pin D type male connector and a
9-pin D type female connector, and Navigator software
(optional)
-20 °C to +70 °C
75 Vac, three phase, 963 Hz
permanent lubrication
II
2
- 20 °C to + 70 °C
ISO 100 (10)
1 (2.2)
:
(A)
Technical Information
Technical Specification
17
213/268