General Information - Agilent Technologies TV 303 Notice De Mode D'emploi

General Information

This equipment is destined for use by professionals. The user should
read this instruction manual and any other additional information
supplied by Agilent before operating the equipment. Agilent will not
be held responsible for any events occurring due to non-compliance,
even partial, with these instructions, improper use by untrained
persons, non-authorized interference with the equipment or any
action contrary to that provided for by specific national standards.
The TV 303 pump is a turbo-molecular pump for high and ultra-high
vacuum applications and can pump any type of gas or gas compound.
It is not suitable for pumping liquids or solid particles. The pumping
action is obtained through a high speed turbine (max. 66000 rpm)
driven by a high-performance 3-phase electric motor. The TV 303 is
free of contaminating agents and, therefore, is suitable for
applications requiring a "clean" vacuum.
It is equipped with auxiliary connectors to supply an additional fan,
to control the vent valve, to be controlled from a remote site by
means of an host computer connected through a serial line (RS232 or
RS485).
The following paragraphs contain all the information necessary to
guarantee the safety of the operator when using the equipment.
Detailed information is supplied in the appendix "Technical
Information".
This manual uses the following standard protocol:
The caution messages are displayed before procedures which, if not followed,
CAUTION!
could cause damage to the equipment.
TV 303 User Manual / 87-901-019-01 (A)
Instructions for Use

General Information

197/268
16