Commissioning - MBM CYE Seie Manuel D'utilisation Et De Maintenance

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 42
4.

COMMISSIONING

4.1
Commissioning for first startup
At the first startup and after a prolonged shutdown, the appliance must be thoroughly cleaned
to eliminate any residue from foreign material (see Routine Maintenance).
Cleaning at commissioning
Do not use pressurised or direct water jets to clean the appliance.
Remove the outer protective film by hand and thoroughly clean all the outside parts of the ap-
pliance. When finished with the cleaning described for the outside of the appliance, proceed as
described in "Daily Cleaning" (see 9. Routine Maintenance).
4.2
Daily activation
Procedure:
1.
Check the cleanliness and hygiene of the appliance.
2.
Make sure that the room exhaust system works properly.
3.
If necessary, plug the appliance into the mains.
4.
Open the network locks upstream the appliance (Gas - Water - Electric).
5.
Make sure that the water drain (if present) is not clogged.
6.
Proceed with the operations described in "Starting production" and the following..
4.3
Daily and prolonged deactivation
Procedure:
1.
Close the network locks upstream the appliance (Gas - Water - Electric).
2.
Make sure that the drain cocks (if present) are "Closed".
3.
Check the cleanliness and hygiene of the appliance (See Routine Maintenance).
In the event of prolonged inactivity, protect the parts more exposed to oxidation as described
in the specific chapter (See Routine Maintenance).
4.4
Starting production
Before proceeding with these operations, see "Daily activation".
When loading the product into the appliance and unloading it, there is a
residual risk of being burnt; this risk can occur coming into unintentional
contact with: cooking compartment - recipients or material processed.
Take appropriate measures for personal protection. Wear protective
equipment suitable for the operations to be performed.
GAS BURNER on / °C flashing - GAS BURNER Off / °C steady (Fig
3/B)
4.5
Turning on/off
Press the "ON/OFF" key to activate the main menu (Fig 3/A).
Press the desired function (Fig 3/C).
In function selection mode, after 5 seconds of inactivity the oven
memorizes the function or value displayed (Display 1 - 2).
To proceed with shutdown:
1. In main menu mode press "ON/OFF" (Fig 3/A).
2. In function mode press "ON/OFF" to stop operation and exit the function.
3. see 4.3 Daily deactivation.
THE PRESENT MANUAL IS PROPERT Y OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
- 10 -
10
A
C
Display 3
B
Display 2
Fig.3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Cyg sérieCyg10Cye6Cyg6Cye102Cye10

Table des Matières