SORHEA MAXIRIS 3000 Notice D'installation page 61

SORHEA
Procedure:
Step
Push the button "Select" for more than 2s until the buzzer
1 signal makes 3 short beeps then a long beep that
Turn the cell on both axes until you have the maximum
2
(refer to the table about the status of the alignment)
3
Move to the next cell by pressing briefly the push
4
The blinking of the LEDS and the beeps of the buzzer
Act on the axes of the cell until you get the maximum tone
5
(refer to the table about the status of the alignment)
Push the push button "Select" for more that 2 seconds
6 until the buzzer makes 3 short beeps in order to leave the
Alignment quality:
Alignment
quality
No signal
Low
Medium
Good
Good
Good
Excellent
Legend :
LED off
indicates the alignment of a cell 1.
sound on the buzzer.
Fasten the adjustment screw of the cells.
button "Select".
are indicating the number of the cell to align.
of the buzzer.
Do step 3 again for each cell.
alignment mode
Status LED
Red Green Orange
LED blinking
Column
Sound signal
Low frequency of
the beeps
Average frequency
of the beeps
High frequency of
the beeps
Continuous
Continuous
Continuous
Continuous
LED on
- 60 -
MAXIRIS 3000 / 3100
max. sound
cells
adjustement screws
max. sound
Observations
Do the alignment again
Do the alignment again
Correct alignment for
distance less than
100m (328 ft)
Correct alignment for
distance greater than
100m (328 ft)
Good Alignment
Good Alignment
Good Alignment