Technical Data; Installation - Progress PHN3320 Notice D'utilisation

34 progress
Problem
The cooking zones do not op-
erate.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven lamp does not oper-
ate.
The display shows 12.00.
Steam and condensation settle
on the food and in the oven.
If you cannot find a solution to the problem
yourself, contact your dealer or the service
centre.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

TECHNICAL DATA

Voltage
Frequency

INSTALLATION

Warning! Refer to "Safety information"
chapter.
Building Under
Warning! Only a qualified and
competent person must do the
installation of the appliance. If you do
not contact a qualified or competent
person, the guarantee becomes invalid
if there is damage.
• Before you install the appliance, fit it with
the applicable hob from the table.
Type
PEM 6000 E
PES 6000 E
Possible cause
The appliance is deactivated.
The clock is not set.
The necessary settings are not
set.
The fuse in the fuse box is re-
leased.
The oven lamp is defective.
There was a power cut.
You left the dish in the oven for
too long
Maximum power
6000 W
5800 W
Refer to the user manual for the hob.
Activate the appliance.
Set the clock.
Make sure that the settings are
correct.
Do a check of the fuse. If the
fuse is released more than one
time, contact a qualified electri-
cian.
Replace the oven lamp.
Set the clock.
Do not keep the dishes in the
oven for longer than 15 - 20
minutes after the cooking ends.
The necessary data for the service centre is
on the rating plate. The rating plate is on
the front frame of the appliance cavity.
.........................................
.........................................
.........................................
230 / 400 V
50 Hz
Type
PES 6060 E
Remedy
Maximum power
7600 W