Replacing The Leg Actuators - Invacare Roze Manuel D'utilisation

Invacare® Roze™

8.8 Replacing the Leg Actuators

A Leg
B Mast Handles
C Screws (eight screws attach
each small base cover)
If the legs of the patient lift do not open and close properly, it
may be necessary to replace one or both of the leg actuators.
42
D Small Base Covers
E Pan Head Screws (eight
screws attach the large base
cover)
F Large Base Cover
1. Test the operation of the legs:
•
Press the CLOSE button on the hand control to close the
legs.
•
Press the OPEN button on the hand control to open the
legs.
2. While holding on to the mast handles, carefully tip the patient lift
back until it rests on the floor.
It is necessary to remove both small base covers before
removing the large base cover.
3. Remove the sixteen screws that attach the small base covers
to the base.
4. Remove the eight pan head screws that attach the large base
cover to the base.
If the left or the right leg of the patient lift does not
operate properly, perform the following steps on the
side of the base necessary to replace the actuator.
If both legs do not operate properly, perform this
replacement procedure on both sides of the base.
5. Locate and disconnect the leg actuator lead wires.
The actuator lead wires will be visible after the large
base cover is removed.
6. Remove the socket head screw and washer that attach the leg
actuator to the base.
7. At the other end of the actuator, remove the socket head screw
and nut that attach the leg actuator to the leg bracket.
8. If necessary, repeat STEPS 5-7 on the opposite side of the base
to remove the other leg actuator.
9. To replace the actuator(s), reverse STEPS 5-7.
1164940-D