Attaching The Battery Charger Mounting Bracket To The Wall; Attaching The Battery Charger Mounting Bracket To The Mast Assembly - Invacare Roze Manuel D'utilisation

3.6 Attaching the Battery Charger Mounting
Bracket to the Wall
Refer to your local regulations concerning proper mounting
procedures.
1. Place the battery charger with mounting bracket A on the wall
at the desired position.
2. With a pencil, mark the middle hole B position.
3. Measure down 6½ inches (16.5 cm) from the pencil mark and
drill one mounting hole.
Install the bottom mounting screw C until there is an
4.
approximate 1/8-inch (3 mm) gap between the screw head and
the wall.
5. Install the battery charger with mounting bracket onto the
bottom mounting screw.
6. Drill the remaining two mounting holes.
7. Install the two remaining mounting screws D through the
mounting bracket and into the wall. Tighten securely.
8. Plug the battery charger into the wall electrical outlet.
ON LED should illuminate.
1164940-D
3.7 Attaching the Battery Charger Mounting
Bracket to the Mast Assembly
A = Battery and battery charger shown in place on mast
assembly.
Setup
17