Checking The Service Light; Resetting The Service Light - Invacare Roze Manuel D'utilisation

Invacare® Roze™

3.5 Checking the Service Light

Each time the lift is assembled, and before using the lift, the
service light should be checked.
1. Assemble the lift.
Examine the control box A or the hand pendant B to see if
2.
the service light C is flashing.
3. Refer to the table.
Service Light Initial Assembly
Flashing Reset the service
light. Refer to
3.5.1 Resetting the
Service Light, page
16.
Not Flashing
16
Reassembly
The lift requires
service. Contact
your local
Invacare dealer
or representative
for service.
The lift is ready for use.

3.5.1 Resetting the Service Light

This procedure should only be performed by a qualified
technician.
This procedure should only be performed after performing
3.5 Checking the Service Light, page 16.
You will hear a sound when the service light has been reset.
The service light is now reset to indicate a service
requirement after a 12 month period or 8000 cycles.
If the service light is required to be set for a period shorter
than 12 months, a special handset and further instructions
are required. Contact Invacare to order this handset and
instructions.
1. Locate the handset A.
2. Press and hold the UP button
B and DOWN button C at
the same time for five seconds.
1164940-D