Assembling The Mast To The Base - Invacare Roze Manuel D'utilisation

Invacare® Roze™

3.2 Assembling the Mast to the Base

DETAIL A
A Mast Assembly
B Base
C Caster
D Top Knob
E Bottom Knob
14
DETAIL B
F Mast Assembly Cable
G Base Cable
H Tube of the Mast Assembly
I Hole in the Base
The mast assembly may be removed from the base for
storage or transporting. The mast assembly MUST be
properly secured to the base assembly before use.
1. Put the base on a level surface so all casters make contact with
the floor.
2. Lock the rear casters (Detail A).
3. Unscrew the top knob and remove it from the base.
4. Loosen the bottom knob, but leave it screwed into the base.
5. Connect the mast assembly cable to the base cable (Detail B).
WARNING!
Risk of injury
– DO NOT place hands between the mast and base
during assembly.
CAUTION!
Risk of Damage.
– DO NOT crush the connected cables between
the mast and base during assembly.
6. Put the tube of the mast assembly into the hole in the base.
7. While supporting the mast assembly, tighten the bottom plastic
knob.
8. Screw the top plastic knob into the hole in the base.
1164940-D