EN
Charging Up the Battery
PLEASE NOTE!
■
Pull the mains adapter out of the plug socket if it is not used for a lengthy period of
time.
– It is essential that you charge up the battery fully before you fi rst use the device
in order to achieve the maximum charging capacity. The fi rst charging process
will last for approx. 3 – 4 hours.
– If the battery is fully discharged during use, it will take approx. 3 hours for the
battery to be recharged.
4. First disconnect the mains adapter from the mains power and then take the device
out of the wall bracket and thus disconnect it from the barrel connector.
Use
PLEASE NOTE!
■
Ensure that there are no larger, sharp objects on the surface which is to be cleaned.
■
Make sure that the MAX marking on the collecting container is not exceeded.
■
Always hold the device horizontally when liquids are sucked up. Make sure that
sucked-up liquids do not get into the motor unit.
■
Do not use the device when it is connected to the mains adapter.
1. Select a nozzle (see the "Device Overview" chapter – "Accessories"). The nozzles
are inserted into the suction opening (9) on the front of the device. The brush
attachment (8) is placed directly onto the crevice nozzle.
2. Switch on the device by sliding the On / Off switch (2) to position I. The device will
start vacuuming immediately.
3. Move the device over the surface to be cleaned.
4. After cleaning, switch off the device by sliding the On / Off switch to position 0.
20
1. Insert the device with the handle (1) pointing downwards
into the wall bracket (13) and, as you do this, make sure
that the barrel connector (14) is plugged into the connect-
ing socket on the bottom of the motor unit (5).
2. Connect the mains adapter to a properly installed, easily
accessible plug socket.
3. Allow the battery of the device to charge up for around
3 – 4 hours in order to achieve the maximum charging ca-
pacity. The control lamp lights up when the device is con-
nected to the mains power.