Closing The Enclosure; Panel-Mount Enclosure; Harsh Enclosure - Mettler Toledo IND560x Guide D'installation

3.10.

Closing the Enclosure

When the IND560x is used in non-metrologically approved applications, after all connections have
been made, close the enclosures as explained next.
3.10.1.

Panel-Mount Enclosure

If no approved sealing is required, simply place the rear cover on the back of the panel-mount
enclosure so the holes line up correctly. Secure with the three Phillips-head screws that were
removed originally.
3.10.2.

Harsh Enclosure

To secure the front cover of the harsh enclosure:
1. Place the terminal with the front cover face-down on a soft, flat surface.
1. Ensure the gasket is in the correct position.
2. Align the holes in the rear housing with the threaded holes in the front cover.
3. Locate the ten screws originally securing the cover and reinstall them by turning clockwise.
4. Torque the screws to 1.5 Nm.
3-42 METTLER TOLEDO IND560x Terminal Installation Manual
W3
Figure 3-50: IND560x (W3) and Power On/Off (W2) Jumper Locations (left) and Positions (right)
Table 3-24: IND560x-PAB Related W3 and W2 Jumper Descriptions
Jumper Position
Closed
W3
Open
Closed
W2
Open
IMPORTANT: Ensure that the IND560 panel mount unit has been installed using only the
gasket that is specified and supplied by Mettler-Toledo
W2
Enables function of IND560x with external battery pack.
Enables function of the IND560x with PSUx or APS768x.
Enables function of IND560x with external battery pack and
enables keyboard On/Off button.
Disables the Power On/Off button on the terminal keypad. Terminal
will always power up automatically after a power outage.
Description
316061929 | 12 | 01/2019