Set&Go Settings; Technical Data - SOMFY DEXXO SMART io Manuel D'installation

EN
12.4. Set&Go settings
NB
Additional settings may have been made with the Set&Go tool, and
are not accessible with the motor interface. These settings are not
described in this manual.

13. TECHNICAL DATA

GENERAL SPECIFICATIONS
Power supply
Max. power consumption
Programming interface
Operating climate conditions
Radio frequency
Number of memorisable channels:
One-way controls (Keygo io, Situo io,
etc.)
CONNECTIONS
Programmable Type
safety input Compatibility
Wired control input
Remote lighting output
Orange light output
Controlled 24 V power supply output
Accessories power supply output
Remote antenna input
Backup battery input
OPERATION
Forced operating mode
Independent remote lighting control
Timed lighting (a er movement)
Automatic closure mode
Orange light warning
Partial opening control
Gradual starting
Closing slowdown zone
11
220-230 V - 50/60 Hz
600 W (with remote lighting,
500 W)
4 buttons - 12 indicator lights
- 20°C/+ 60°C - IP 20
868 - 870 MHz
< 25 mW
Total/partial opening control : 30
Auxiliary output control: 4
Integrated lighting control: 4
Dry contact: TX/EX photoelec-
tric cells - Bus cells - Reflex
photocell
Dry contact: NO
Dry contact
Max. 230 V - 500 W
• either 5 fluocompact or LED
lights
• or 2 power supplies for
low-voltage LEDs
• or 1 halogen light, max. 500 W
24 V - 15 W
Yes: for possible TX/RX photo-
electric cells auto-test
Max. 24 V - 400 mA
Yes: compatible with io antenna
(ref. 9013953)
Yes: compatible with 9.6 V battery
(part no. 9001001)
Battery life: 24 hours; 3 cycles
depending on door
Charging time: 48 hours
By pressing the "+" and "-" but-
tons before auto-programming
Yes
60 s
Yes: short or long closure
time-delay
2 s in sequential mode with
closure time-delay
Yes
Yes
Programmable: 3 possible values
DEXXO SMART io
Copyright © 2018 SOMFY ACTIVITES SA. All rights reserved.