Tips And Advice On Installation; Additional Settings - SOMFY Sunea 40 RTS DC Notice Originale

2. 4. TIPS AND ADVICE ON INSTALLATION

2. 4. 1. Questions about the Sunea 40 RTS DC?
Observations
The awning does
The wiring is incorrect.
not work.
The control point is not compatible.
The Somfy RTS control point used has
not been programmed into the motor.
The awning stops
The crown is incorrectly positioned.
too soon.
The end limits have been incorrectly set. Readjust the end limits

2. 4. 2. Additional settings

2. 4. 2. 1. Up end limit re-adjustment (only in case of manual setting, awning without blocker for
up end-limit)
Move the motor to the up end limit previously set in
1)
section 2.3.1.4 with the "Up" button.
Press simultaneously for 5 seconds the "Up" and
2)
"Down" buttons, the motor will jog in both directions.
Move to the new position with the "Up" or "Down"
3)
buttons.
&RQ¿UP WKH QHZ SRVLWLRQ E\ SUHVVLQJ  VHFRQGV WKH
4)
"My" button. The motor will jog in both direction. The
new end limits setting is memorized.
2. 4. 2. 2. Down end limit re-adjustment
Move the motor to the down end limit previously set in
1)
section 2.3.1.3 or 2.3.1.4 with the "Down" button.
Press simultaneously for 5 seconds the "Up" and
2)
"Down" buttons, the motor will jog in both directions.
Move to the new position with the "Up" or "Down"
3)
buttons.
&RQ¿UP WKH QHZ SRVLWLRQ E\ SUHVVLQJ  VHFRQGV WKH
4)
"My" button. The motor will jog in both directions. The
new end limit setting is memorized.
8
Possible causes
Images are not contractually binding.
Solutions
Check the wiring and modify it if necessary.
Check for compatibility and replace the
control point if necessary.
Use a programmed RTS control point or
program this RTS control point.
Fit the crown correctly.
1)
0.5 s
3)
1)
0.5 s
3)
Copyright © 2014 Somfy SAS. All rights reserved.
2)
5 s
4)
2 s
2)
5 s
4)
2 s