Assembly - Vacuum Operation - Only Model 441 (With Model 440 As Accessory) - Solo 440 Instructions D'emploi

Masquer les pouces Voir aussi pour 440:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 34
6.2 Assembly - vacuum operation – only
model 441 (with model 440 as
accessory)
Fit the following parts for the vacuum operation:
Exhaust air elbow (20) to be fitted to the standard
machine.
Catcher (21) to be fitted to the exhaust air elbow.
Vacuum pipe (19) to be fitted to the standard machine.
[Note: When preparing model 440 with vacuum
operation accessory kit 49 00 546 for the first time, also
fit the anti-static wire in accordance with the details
supplied with the accessory kit. For model 441, the
anti-static wire is already fitted as standard.]
Exhaust air elbow assembly (20)
Fig. 6
Tip: To make the assembly easier, the standard
machine can be positioned on a level surface, air filter
side down. For this, ensure that the tank cap is tightly
secured to prevent fuel spillage.
! Undo clip (26) on exhaust air elbow (20).
a) Push exhaust air elbow (20) with groove (27) over
cam (23) of the standard machine.
The arrows on the exhaust air elbow and the
standard machine must be aligned accurately, when
the parts are pushed together (the wide groove (27)
over the large cam (23), and the narrow groove over
the smaller cam).
b) Turn the exhaust air elbow 45º above the stand (14);
do not tighten excessively!
c) Flick lock (6) forward.
! Secure clip (26).
Dismantling the exhaust air elbow
! Undo clip (26).
! Flick lock (6) back up.
! Turn the exhaust air elbow back, so that the arrows
are aligned again accurately.
! Pull the exhaust air elbow from the standard
equipment.
Preparing the equipment for use
Catcher assembly (21)
Fig. 7
! Open Velcro strap (27) on catcher.
! Push the catcher so far over the elbow, that the
entire width of the Velcro strip is located behind the
bead (28) on the reducing part of the elbow.
! Tighten and close the Velcro strip.
! Secure the shoulder strap to the catcher eyes.
To dismantle the catcher, open the Velcro strip and
remove the catcher from the exhaust air elbow.
Vacuum pipe assembly (19)
Fig. 8
Fig. 9
Open the fan cover wide. Push vacuum pipe cams (30)
into grooves (31) on the inner ring of the fan casing.
Ensure that the large cam is located in the wide groove
and the small cam in the narrow groove. Secure the
vacuum pipe by turning it clockwise.
Note: To enable the power tool, which has been
converted for vacuum operation, to be stored on stand
(14), turn the exhaust air elbow back after undoing clip
(26) and flipping lock (6) up. Afterwards, the arrows on
the elbow and the standard machine must be aligned
again accurately.
With a screwdriver,
push into the side
opening of the fan
cover to release it.
ENGLISH
11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

441

Table des Matières