Power Adapter; Monitor/Dvr; Cameras - Sygonix 2300294 Notice D'emploi

b) Power adapter
• The design of the power adapter complies with protection class II. Only connect the power adapter to a
standard mains socket connected to the public supply grid.
• The mains socket for the power adapter must be close to the monitor/DVR and easily accessible.
• The power adapter is only suitable for use in dry, enclosed indoor spaces; it must be protected from
moisture or dampness. There is a risk of a fatal electric shock!
• Do not unplug the power adapter from the mains socket by pulling on the cable. Grip the sides of the
plug, and then remove the plug from the mains socket.
• Do not touch the power adapter if there are any signs of damage, as this may cause a fatal electric
shock!
Fully deenergise the mains socket to which the power adapter is connected (e.g. turn off the correspond-
ing circuit breaker or unscrew the fuse, and then turn off the residual current circuit breaker).
Unplug the power adapter from the mains socket and take the product to a specialist repair centre.
• Use only the included power adapter to operate the product. If the power adapter is faulty, it must be re-
placed by an identical, stabilised power adapter with the same technical specifications (voltage/current).
c) Monitor/DVR
• The monitor/DVR is only suitable for dry, enclosed indoor spaces. Do not expose it to direct sunlight,
heat, cold, humidity or moisture, otherwise it will be damaged. Do not place containers filled with liquids
on or near the monitor/DVR.
• Place the monitor/DVR on a flat, horizontal, stable surface so that it cannot tip over or fall down. Use a
suitable underlay to protect valuable furniture surfaces from dents or scratches. The monitor/DVR can
also be secured with screws using two openings in the base.
• Do not apply pressure to the surface of the display, because this might cause scratches, or break the
display and thus permanently damage it. This will void the warranty!
d) Cameras
• Both cameras are suitable for indoor and outdoor use (IP65). However, they must never be used in or
under water, as this will destroy them.
• The voltage/power supply connection plugs and the BNC connectors are not protected from moisture/hu-
midity. They must therefore be placed in a dry place (for example, in a suitable connection box or similar).
• Make sure that the cables are not squeezed, bent or damaged by sharp edges. The cables must be
laid firmly.
• Operation of the cameras should not replace personal supervision of children or people with special
needs, it serves to support this supervision.
• Mount the cameras so that they are not oriented directly to bright light sources such as the sun or spot-
light. This will lead to an overexposed and distorted image and may damage the image sensor in the
event of constant exposure.
30