Installation, Operating and Maintenance Instruction
Removing the shaft seal: See "Replacing the
Shaft Seal".
Clean all parts. If the pump is to be reassembled
at a later date, carefully store all parts and protect
from corrosion.
8.9 Repairs
Clean all parts and check for wear. In case of
excessive wear, parts must be replaced. This is a
practical opportunity to renew parts such as seals (O-
rings), roller bearings and shaft seals.
Wearing parts and dimensions:
A
MP 100-english
Article No 771074011
B
C
D
G
page 98
E
F
A
Model MP, MPA, MPAI
Issue 01/2007
Revision 02