Step 8, Install Filters; Step 9, Finalize Installation - Monogram ZV830 Mode D'emploi

8 INSTALL FILTERS
IMPORTANT: Check to be sure that the main ON/OFF
switch next to the motor is in the ON position.
• Remove protective films on the grease filters and
filter cover panel.
• Insert the black charcoal filter into the opening.
Push the latch on both sides toward the center
and engage the flange. Release latches to secure.
• To remove the filter, push the latches toward
the center and pull downward.
• Install the metal grease filter into the hood
support channels directly below the charcoal
filter.
NOTE: The charcoal filter should not be used
without the metal filter secured below.
• To close the filter cover panel, push up on both
sides at the front corners to engage the latch.
Installation Instructions
INSTALLATION—RECIRCULATING
Push-button
switch
(horizontal
view from
inside
opening)
9 FINALIZE INSTALLATION
• Remove all tape and packing material.
• Refer to the Owner's Manual for operating
instructions.
18