Care And Cleaning; For Your Safety; Mesh Grease Filters And Drip Tray - Monogram ZV48TSFSS Manuel Du Propriétaire

Masquer les pouces

Table des Matières

Les langues disponibles

For your

Before servicing or cleaning unit, switch power

off at service panel and lock the service

safety

disconnecting means to prevent power from

being switched on accidentally. When the

service disconnecting means cannot be

locked, securely fasten a prominent warning

device, such as a tag, to the service panel.

Mesh grease

Some models have 2 metal reusable grease

filters and drip tray.

filters and

The metal filters and drip tray trap grease

drip tray

released by foods on the cooktop. The filters

(on some

also help prevent flaming foods on the cooktop

from damaging the inside of the hood.

models)

For this reason, the filters must ALWAYS be

in place when the hood is used. The grease

filters and drip tray should be cleaned every 6

months, or as needed.

To clean the drip tray, drain and wipe all

excess grease with a dry paper towel. Wash

with hot soapy water. Dry with a clean cloth.

To clean the grease filters, soak them and

then swish them around in hot water and

detergent. Don't use ammonia or ammonia

products because they will darken the metal.

Do not use abrasives or oven cleaners. Light

brushing can be used to remove embedded dirt.

Rinse, shake and let them dry before replacing.

To remove:

Grasp the filter lock and pivot it open to

release. Pull the filter down and out. Remove

both filters. Grasp the drip tray, on both sides,

by the front edge and carefully lift it up and out.

To replace:

1. Place and seat the drip tray into the hood

2. Place the bottom of the filter in the lower

3. Push the top of the filter back, open the filter

49-80393-4

track, making sure the rear tabs on the tray,

hook into the back slots in the hood track.

hood rail.

lock and snap it into place.