Step 8, Install Filters; Step 9, Finalize Installation - Monogram ZV830 Mode D'emploi

INSTALLATION—VENTED TO THE OUTSIDE
8 INSTALL FILTERS
IMPORTANT: Check to be sure that the main ON/OFF
switch next to the motor is in the ON position.
• Remove protective films on the grease filters and
filter cover panel.
NOTE: The charcoal filter is not required for this
installation.
• Tip the filter into the left or right side of
the opening. Lift the filter to the opposite
side and into the filter lock.
• To remove the filter, push the latch toward
the center and pull downward.
• To close the filter cover panel, push up on both
sides at the front corners to engage the latch.
Installation Instructions
Push-button
switch
(horizontal
view from
inside
opening)
13
9 FINALIZE INSTALLATION
• Check to be sure all tape and packaging materials
have been removed.
• Refer to the Owner's Manual for operating
instructions.