Step 2, Install Hood Mounting Screws; Step 3, Install Duct Bracket; Step 4, Mount The Hood - Monogram ZV830 Mode D'emploi

2 INSTALL HOOD MOUNTING SCREWS
The mounting screws must enter the horizontal support
or wall studs.
• With the template taped in place, use a punch
to mark mounting bracket screw locations.
"
• Drill 1/8 pilot holes in 2 of the punched locations
in the lower bracket.
• Remove the template.
• Install the mounting screws; leave 1/4" gap between
the screw head and the wall. This will allow the keyhole slot
on the hood frame to engage the screw head.
1-1/4"
TOP
MOUNTING
NOTE: Top HOLE
mounting
screws MUST DRILL 1/8"
engage wood
PILOT HOLE
support.
9-7/16" 15-7/16"
BOTTOM
MOUNTING
HOLE
Installation Height
Align Bottom Edge With
Pencil Line Indicating
Bottom of Hood
IMPORTANT: Use the mounting screws provided. DO NOT USE
DRYWALL SCREWS.
• Check to be sure the mounting screws are horizontally level.
3 INSTALL DUCT BRACKET
The duct bracket should be installed against the back wall
and flush with the ceiling. This bracket will hold the duct cover
in place at the top.
Secure the bracket to the wall:
• Align the diamond centerline cutout on the bracket
to the penciled centerline on the wall.
• Mark 2 screw hole locations in the wall.
"
• Drill 1/8 pilot holes in the marked locations.
• If pilot holes do not enter wood studs, enlarge the holes
"
to 3/8 and install metal wall fastener anchors (provided).
• If mounting directly to a masonry wall, obtain appropriate
#10 masonry screw anchors. Drill and install per the
fastener supplier's instructions.
• Drive screws, by hand, into the fasteners to allow anchors
to expand. Remove the screws.
• Secure the bracket to the wall with wood screws and/or fasteners.
Centerline cutout
Installation Instructions
INSTALLATION—RECIRCULATING
1-1/4"
10-1/16"
TOP
MOUNTING
HOLE NOTE: Top
mounting
DRILL 1/8" screws MUST
engage wood
PILOT HOLE
support.
REAR WALL
MOUNTING TEMPLATE
15-7/16" 9-7/16"
C L
BOTTOM
MOUNTING
HOLE
Installation Height
Align Bottom Edge With
Pencil Line Indicating
Bottom of Hood
4 MOUNT THE HOOD
WARNING:
the hood onto the mounting screws.
• Lift the hood onto the mounting screws.
• Check level and mark bottom screw locations.
• Remove the hood.
• Drill 1/8" pilot holes in the marked location.
• If pilot holes do not enter studs, enlarge the holes to 3/8"
and install metal wall fastener anchors (provided).
• Lift the hood onto the mounting screws.
• Install lower screws to pull the hood tight against the wall.
• Tighten the top mounting screws.
Tighten
screws
Install
screws
15
2 people are required to lift and position