Table Des Matières; Design Information; Product Dimensions And Clearances; Installation Options - Monogram ZV830 Mode D'emploi

Masquer les pouces Voir aussi pour ZV830:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CONTENTS
Product Dimensions and Clearances ....................................................3
Installation Options ........................................................................................3
Advance Planning, Ductwork, Framing ................................................4
Power Supply ....................................................................................................4
Duct Fittings ......................................................................................................5
Tools and Materials Required ....................................................................6
Remove the Packaging ................................................................................6
Determine Installation Height ..................................................................7
Wall Mount Installation Heights ..............................................................7
Check Installation Hardware......................................................................8
Ductwork, Wiring Locations ......................................................................9
Step 1, Install Framing for Hood Support ............................................9
Step 2, Install Hood Mounting Screws ................................................10
Step 3, Install Duct Bracket......................................................................10
Step 4, Mount the Hood ............................................................................10
Step 5, Connect Ductwork........................................................................11
Step 6, Connect Electrical ........................................................................12
Step 7, Install Duct Covers........................................................................12
Step 8, Install Filters ....................................................................................13
Step 9, Finalize Installation ......................................................................13

PRODUCT DIMENSIONS AND CLEARANCES

10-7/8"
*Height
to
Ceiling
18 - 7/8"
* The Supplied Duct Cover Fits 8' to 10' Ceiling Heights.
The vent hood must be installed 24
"
30
max. above the cooking surface. The hood
installation height above the cooking surface
depends upon ceiling height.
The telescopic duct cover conceals the ductwork
running from the top of the hood to the ceiling.
The supplied duct cover is sized to reach 8' to
10' ceiling heights. See page 7.
ZX83012 Accessory - Duct accessory for ceiling
heights of 10' to 12'. See page 7.

Design Information

13-1/4"
5-7/8"
29-7/8"
"
min., and
Ductwork, Wiring Locations ....................................................................14
Step 1, Install Framing for Hood Support..........................................14
Step 2, Install Hood Mounting Screws ................................................15
Step 3, Install Duct Bracket......................................................................15
Step 4, Mount the Hood ............................................................................15
Step 5, Size and Cut Duct Piece ............................................................16
Step 6, Connect Electrical ........................................................................17
Step 7, Install Duct Covers........................................................................17
Step 8, Install Filters ....................................................................................18
Step 9, Finalize Installation ......................................................................18

INSTALLATION OPTIONS

NOTE: Installation height should be measured from
the cooking surface to the lowest part of the hood.
This hood may be installed onto a wall and vented
to the outdoors, or it can be installed for recirculating
operation. All necessary parts for recirculating
operation are supplied with the hood. No kits required.
This hood can be installed over any 30" Monogram
electric cooktop or gas cooktop. It cannot be
installed over a Monogram Professional cooktop
or range.
3
24" Min.
30" Max.

Publicité

Table des Matières
loading

Table des Matières