Avvertenze Sulla Sicurezza; Alimentazione Elettrica; Utilizzo; Safety Related Warnings - ApenGroup aermaxline AX020EC Manuel D'utilisation, D'installation Et D'entretien

Aérotherme électronique
Table des Matières

Publicité

cod. HA0055.00W ed.D-2012
IT
termiche, aerauliche ed elettriche
dell'aerotermo, il nome del co-
struttore con tutti i suoi riferimenti
ed il paese di destinazione a cui è
destinato l'aerotermo.
2. AVVERTENZE
SULLA SICUREZZA
2.1. Alimentazione
elettrica
L'apparecchio deve essere corret-
tamente collegato ad un efficace
impianto di messa a terra, eseguito
secondo le norme vigenti.
Avvertenze:
• Verificare, con l'ausilio di persona-
le abilitato, l'efficienza dell'impianto
di messa a terra.
• Verificare che la tensione della rete
di alimentazione sia uguale a quella
indicata sulla targa dell'apparecchio
e in questo manuale.
• Non scambiare il neutro con la
fase. L'apparecchio può essere
allacciato alla rete elettrica con una
presa-spina solo se questa non con-
sente lo scambio tra fase e neutro.
• L'impianto elettrico, ed in particola-
re la sezione dei cavi, deve essere
adeguato alla potenza massima
assorbita dall'apparecchio, indicata
nella sua targa e in questo manuale.
• I cavi elettrici devono essere tenuti
lontano da fonti di calore.
IMPORTANTE: a monte del cavo
di alimentazione, è obbligatoria
l'installazione di un interruttore
onnipolare con fusibili ed aper-
tura dei contatti superiore ai 3
mm. L'interruttore deve essere
visibile, accessibile e posizionato
ad una distanza inferiore ai 3 metri
rispetto all'apparecchio.Ogni
operazione di natura elettrica
(installazione e manutenzione)
deve essere eseguita da perso-
nale abilitato.

2.2. Utilizzo

L'uso di un qualsiasi apparecchio
alimentato con energia elettrica
non va permesso a bambini o a
persone inesperte.
È necessario osservare le seguenti
indicazioni:
• non toccare l'apparecchio con
parti del corpo bagnate o umide e/o
a piedi nudi;
• non toccare le parti calde dell'ap-
parecchio, quali ad esempio i con-
dotti dell'acqua calda;
• non appoggiare alcun oggetto
sopra l'apparecchio;
• non toccare le parti in movimento
dell'apparecchio.
ATTENZIONE: Non installare in
ambienti con presenza di oli di-
spersi in atmosfera (es. sostanze
grasse alimentari, ...).
8
GB
2. SAFETY-RELATED
WARNINGS
2.1. Power
supply
The equipment shall be properly
connected to an efficient grounding
system, complying with existing
regulations.
Cautions:
• Check the efficiency of the
grounding system with the help of
qualified personnel.
• Check that the mains power supply
is the same as the power input stated
on the equipment nameplate and in
this manual.
• Do not mistake the neutral for
the live wire. The equipment can
be connected to the mains power
supply with a plug-socket only if the
latter does not allow live and neutral
to be swapped.
• The electrical system and, more
specifically, the cable section,
must be suitable for the equipment
maximum power input, shown on
the nameplate and in this manual.
• The electric cables must be kept
away from heat sources.
IMPORTANT: it is compulsory to
install, upstream of the power
cable, a fused omnipolar switch
with contact opening greater
than 3mm. The switch must be
visible, accessible and placed
at a distance lower than 3
metres from the equipment. Any
electrical operation (installation
and maintenance) must be
performed by qualified staff.
2.2. Use
D o n o t a l l o w c h i l d r e n o r
inexperienced people to use any
electrically powered equipment.
The following instructions must be
followed:
• do not touch the equipment with
wet or damp parts of your body and/
or with bare feet;
• do not touch the hot parts of the
equipment, such as the hot water
ducts;
• do not place any object over the
equipment;
• do not touch the moving parts of
the equipment.
ATTENTION: Do not install where
leakages of oils in the atmosphere
(e.g. dietary fats) are present.
AX EC

Publicité

Table des Matières
loading

Table des Matières